What are connected routes?
The difference is exactly that: a connected route is a route to network that is directly attached to the interface. Local is the route that belongs to the router/switch itself.
What is the difference between a connected route and a local route?
A connected route is one that is assigned directly to an interface. A local route is one that is one that is not known by a protocol.
What is a directly attached static route?
A directly attached, or directly connected static route, uses the exit interface to forward traffic to the intended destination. This is in contrast to the recursive static route which used the next hop IP address of the router along the path to the destination.
Where do directly connected routes come from?
Directly connected routes—These routes come from the active router interfaces. Routers add a directly connected route when an interface is configured with an IP address and is activated. Remote routes—These are remote networks connected to other routers.
What does directly connected mean?
: being on a common shaft : direct-coupled.
How do you do a static routing?
Configuring Static Routes
- Navigate to the Configuration > Network > IP > IP Routes page.
- Click Add to add a static route to a destination network or host. Enter the destination IP address and network mask (255.255.
- Click Done to add the entry. Note that the route has not yet been added to the routing table.
What is floating static route?
Floating static routes are static routes that have an administrative distance greater than the administrative distance of another static route or dynamic routes. They are very useful when providing a backup to a primary link, as shown in Figure 2-66.
What is the administrative distance of directly connected route?
Connected routes always take precedence over static or dynamically discovered routes because they have the administrative distance value of 0 (the lowest possible value).
What is a directly connected network?
A directly connected network is a network that is directly attached to one of the router interfaces. The network address and subnet mask of the interface, along with the interface type and number, are entered into the routing table as a directly connected network.
Which statement is true concerning directly connected routes?
Which statement is true concerning directly connected routes? They appear in the routing table as soon as cables are connected to the router. They appear in the routing table when the routing protocol is configured on the router.