What is a Teel pump used for?

What is a Teel pump used for?

Teel self-priming to 20 ft., corrosion-resistant centrifugal pumps Model Numbers 4RJ40, 4RJ41, 4RJ42, 4RJ43, and 4RJ44, are for use in commercial irrigation, water transfer, draining, and general de-watering applications.

How far can a 1/3 HP sump pump push water?

1/3 HP Submersible Sump Pumps For most average-sized homes in areas with average water tables, a 1/3 HP sump pump should be sufficient. Typically, 1/3 HP pumps can handle 7′ – 10′ vertical lifts from the sump pit if they have one 90-degree elbow and a horizontal pipe run between 3 feet and 25 feet.

What is the difference between 1/2 hp and 1/3 HP sump pump?

When used in similar conditions, a 1/2 horsepower pump will pump more water and lift it higher than a 1/3 horsepower pump. Most new sump pumps will have a chart or graph in the instructions or on the box that shows the flow versus height of lift for both sizes.

How many GPH is a 1/3 hp pump?

1/3 HP Submersible Utility Pump 2000 GPH.

Where are Dayton pumps made?

Made in the U.S.A! Please note we sell replacement models. No Repair Parts.

Who makes Dayton water pumps?

TEEL and Dayton are a registered trademark of Grainger, Inc.

How far can a 3/4 HP pump push water?

3/4 HP pumps also tend to have a higher water capacity, with estimates capping out at 13 GPM. How does the 3/4 HP submersible pump stand up in terms of power and length, though? Generally speaking, this pump can reach down into wells that drop 30 feet deep.

Whats stronger 1/2 hp or 1/3 hp?

Many plumbers recommend the 1/2 horsepower garbage disposal over the 1/3 hp as it’s typically better constructed and has a little more power. Although, you should keep in mind, this is still a lower powered disposal, and is only suitable for light use.

How much power does a 1/3 HP sump pump use?

Pumps and Air Conditioners Estimated Watts
* Well Pump 1/3 hp 750 (Running) 1400-3000 (Starting)
* Well Pump 1/2 hp 1000 (Running) 2100-4000 (Starting)
* Sump Pump 1/3 hp 800 (Running) 1300-2900 (Starting)
* Sump Pump 1/2 hp 1050 (Running) 2150-4100 (Starting)

How many amps does a 1/3 HP sump pump draw?

6 amps
About 6 amps is average for a 1/3 hp motor operating at 120 volt. Its a good idea to have it on a dedicated circuit or a circuit thats ” known” not to have alot of load on it.