How do you put a Kenmore washer in diagnostic mode?

How do you put a Kenmore washer in diagnostic mode?

How do I put it into diagnostic mode? Turn the dial to Drain/Spin, Press Pause/Cancel to turn off the control. Within 5 seconds, press and hold PAUSE/CANCEL and OPTIONS until the LED’s start chasing. Turn the dial one click clockwise to test each of the washer components (water valves, door lock, and motor).

Is there a reset button on a Kenmore washing machine?

To reset your Kenmore washer and, since Kenmore washers do not have a reset button, go ahead and turn the washer off. Disconnect the washer from its power source. Then, wait for about three to five minutes. Now reconnect the washing machine to the power source and turn it on again.

How do you take the top off of a Kenmore Elite washer?

Turn the water off to the washer at the shutoff valves behind the appliance. 2. Slide a putty knife between the top lid and the washer cabinet in the front and push down on the two metal tabs to detach the lid from the cabinet. Flip the top lid back so it is resting on the rear hinges against the back wall.

How to fix a Kenmore top load washer?

Before you do anything,unplug the machine and put on protective gloves.

  • Start by taking a closer look at the latch of the door.
  • Inspect the latch.
  • The next thing you will need to do is check your door lock and switch assembly.
  • Next,grab a multimeter and check both of the switches.
  • Grab a flashlight and get an even closer inspection of the lock itself.
  • What is the best Kenmore washing machine?

    Kenmore 22352 4.2 cu. ft. Top-Load Washer w/Deep Fill, White Kenmore 20232 3.5 cu. ft. Top-Load Washer w/Porcelain Basket – White Kenmore 20362 3.8 cu. ft. Top-Load Washer w/Stainless Steel Basket – White

    How to install a Kenmore topload washing machine?

    Use a sink aerator thread to hose connection adapter to attach the water supply hose to the sink faucet.

  • Connect the other end of the water supply hose to the cold-water connection on the back of the washing machine.
  • If your water supply hose is not long enough,you will need to purchase a longer hose or an extension for your existing hose.
  • How to manually unlock a Kenmore front load washing machine?

    Press “pause” or “start” to open an electrical lock. This may sound obvious,but you may not have pressed the pause button to stop the cycle.

  • Turn the washing machine off and unplug it. If pausing the cycle doesn’t unlock the door,turn the machine off.
  • Slide a flathead screwdriver in the seam of the bottom panel for a front loader.